Audio Technica - AT2035

The AT2035 is intended for use in applications
Professional for which there is already a source
external power. It requires phantom power 11
52V DC that can be provided by a mixer or a mixer
or from an independent source to be connected in series such that
phantom power AT8801 single-channel or CP8506 four
Audio-Technica channels.
The output of the microphone is symmetrical low impedance, XLR
male, 3 pins. The signal is symmetrical between pins 2 and 3,
the hot spot is two (the positive voltage on the hot spot is
generated a positive sound pressure on the capsule). There
ground (shield) is on pin 1.
To avoid phase cancellation and poor sound
quality, all mic cables must be connected so
consistently: Pin 1-Pin 1, etc.
A high pass filter integrated 80 Hz allows easy switching from
flat frequency response in mitigating serious. The position
highpass is used to make the microphone less sensitive to the "pops"
when used in proximity of voice. It also serves to
reduce sensitivity to low-frequency ambient noise (such
traffic, air-handling systems, etc.), Reverb
the room and mechanically coupled vibrations.
When using the microphone, hook the cable arm or
at the foot of micro leaving soft micro level. It's here
the most effective way to absorb shocks and you may
less accidentally pulling the microphone out of its
support.
Avoid leaving the microphone in direct sunlight or in places
where the temperature is above 43 ° C (110 ° F) for a period
extended. Extremely high humidity should also be avoided.