Static Microphone

Pair of high-end microphone TLM 170 double box

ARTICLE N° 9282
  • Acoustical operating principle pressure gradient transducer
  • Directional pattern Omnidirectional, wide cardioid, cardioid, hypercardioid, (Figure 8)
  • Frequency Response 20 Hz to 20 kHz
  • Sensitivity at 1 kHz, 1 kohm 8 mV / Pa
  • rated impedance 50 Ohms
  • load impedance 1 kOhm
  • Equivalent noise level at the input, according to CCIR 468-3 26 dB
  • Equivalent noise level at the input, DIN / IEC 651] 14 dB (A)
  • signal / noise ratio, according to CCIR 468-3 68 dB
  • signal / noise ratio according to DIN / IEC 651 80 dB
  • maximum SPL for THD = 0.5% 144 dB
  • maximum SPL for THD = 0.5%, pre-activated attenuator 154 dB
  • maximum output level 10 dBu
  • dynamic range of the microphone amplifier in accordance with DIN / IEC 651 130 dB
  • d voltage phantom power 48 V ± 4 V
  • consumed intensity e 3 mA
  • Release XLR 3M
  • Weight 625 g
  • Diameter 60 mm
  • length 152 mm
The TLM 170 R was the first microphone to use the successful fet 100 technology with a balanced transformerless output stage, it offers a clean noise level extremely low and an impressive dynamic range.

Its five directional characteristics are selectable via a rotary switch. In the sixth position, marked "R", the directivity is controlled remotely from the feed N 248. No specific cable is necessary in this case.
Capsule type
 Capacitor
Application
 Singing, Speaking voice, Guitar / bass amplifier, Drum / percussions, Strings instruments
Directivity
 Cardioid, Hypercardioid, Supercardioid, Bidirectional (Figure-8), Omnidirectional
Switchable pad
 Yes
Switchable Bass-Cut filter
 Yes
Shockmount included
 Yes
Complete set
 Yes
Power supply
 Via +48 V phantom power supply
Connectors
 XLR male 3 pins
Packaging
 Single unit

Spotlight on